XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Roll bar angles https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=5081 |
Page 1 of 1 |
Author: | edlan [ Mon Feb 26, 2007 05:12:39 ] |
Post subject: | Roll bar angles |
I noticed I can adjust the angle of the roll bars for front and rear by adjusting the length of the tie rod. Generally I try to run by roll bars level and when I take off my roll bar, I make sure it lies flat. Also with calipers I measure to make sure each tie rod is approximately the same length. Is there any sort of tuning effect of making the tie rods longer on both sides, thus increasing the angle of the tie rods (making them less flat, and more perpendicular)? |
Author: | Bobby Flack [ Thu Mar 01, 2007 20:42:15 ] |
Post subject: | |
Author: | yinkymoka [ Fri Mar 02, 2007 20:50:48 ] |
Post subject: | Tie rod hieghts |
Author: | Hurricane '007 [ Wed Dec 26, 2007 15:40:29 ] |
Post subject: | |
Author: | Tonyv [ Thu Dec 27, 2007 00:26:41 ] |
Post subject: | |
Author: | Hurricane '007 [ Thu Dec 27, 2007 00:39:13 ] |
Post subject: | |
Author: | Ryan_Maker [ Thu Dec 27, 2007 02:42:23 ] |
Post subject: | |
Author: | NunoGancho [ Thu Dec 27, 2007 11:43:10 ] |
Post subject: | |
Author: | Hurricane '007 [ Thu Dec 27, 2007 13:06:09 ] |
Post subject: | |
Hi NunoGancho, just check the instruction manual. The inner position should be used only on low traction tracks, the outer one, which is also the initial position, is used on high traction tacks. |
Author: | NunoGancho [ Thu Dec 27, 2007 14:35:05 ] |
Post subject: | |
ehhehe Thanks, i am in the process of building the car, i have tried to see what was the effect in the manual, i will check it again heheh, Thanks. |
Author: | Tonyv [ Fri Dec 28, 2007 01:05:09 ] |
Post subject: | |
Author: | NunoGancho [ Fri Dec 28, 2007 11:44:32 ] |
Post subject: | |
Author: | YELLOWSHARK [ Fri Dec 28, 2007 13:32:54 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |