XRAY - Model racing cars

Hello all,

Just put a 007 kit together, but needed to remove one of the front shocks, what is the prpper way of getting the shocks off of the bottom screw? And then putting it back on the bottom screw.

If I remeber when I initally installed it it just slid right on the bottom screw.

thanks in advance

Ken

You should be able to use the large allen wrench (3mm I think). The steel ball inside the shock end has a hex hole for the wrench. Make sure you screw the small set screw into the arm enough, so that you leave room to insert the hex wrench into the steel ball end to mount/dismount the shock.