XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Setup Help https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=462 |
Page 1 of 1 |
Author: | leenoble0 [ Mon Nov 15, 2004 10:46:57 ] |
Post subject: | Setup Help |
Author: | Sam_Smith [ Mon Nov 15, 2004 14:21:13 ] |
Post subject: | Re: Setup Help |
Author: | Tonyv [ Mon Nov 15, 2004 14:25:19 ] |
Post subject: | |
Author: | leenoble0 [ Mon Nov 15, 2004 17:10:22 ] |
Post subject: | |
Author: | Sam_Smith [ Mon Nov 15, 2004 17:34:12 ] |
Post subject: | |
Author: | Big Jimmy G [ Mon Nov 15, 2004 20:23:46 ] |
Post subject: | |
Hi, I also usually run on a tight carpet track, stock motors and rubber tires. I did a good deal of testing last meeting and ended up with a setup very similar to the one posted above, except for running 40wt oil in the front shocks. However, I would get this down to 30wt and go up one spring all round as the track was VERY small (10 x 15m) and tight. Are you allowed other tires and additive? The tire of choice at my track is the CS22 with the insert that comes with them when you buy them glued up. Oh, and plenty of additive too! T27s can work if your club ban additive ( ), just run a slightly firmer insert in the front would be my advice. James |
Author: | leenoble0 [ Mon Nov 15, 2004 23:28:14 ] |
Post subject: | |
Author: | Sam_Smith [ Tue Nov 16, 2004 01:56:29 ] |
Post subject: | |
Author: | crashmaster [ Tue Nov 16, 2004 03:24:06 ] |
Post subject: | Carpet Setup with foam tires |
Front Jaco purple/orange foam tires 3 deg c-hubs 33 lbs springs 40 wt oil two clicks on the adj shocks all the way out on the shock mount med on the diff center center on the kickup 2 neg camber 0 deg toe camber link stock Rear Jaco purple 28 lbs springs 40 wt oil three clicks all the way out on the shock mount hard on the diff center center on kickup 2 neg camber 2 deg toe camber link stock I hope this helps. This is a good basic med traction setup for carpet. |
Author: | crashmaster [ Tue Nov 16, 2004 17:12:12 ] |
Post subject: | Forgot droop settings |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |