XRAY - Model racing cars

When I clip a front wheel against the boards at a track, it breaks the steering knuckle at the bottom resulting in the loss of the bolt and the steel bush that it pivots in. The only way to buy the replacement part is as a set of four - two long and two short. As I have only ever lost the bottom one, I will end up with a number of top bushes left over.

I'd like to suggest that XRay make them available as either long or short not as all four (two of each) together as it would be more cost effective to buy only the ones necessary and not have leftovers of ones that aren't.

BTW I see also that there is a composite option part which are 1/3 the cost of the steel ones, perhaps this could be done in the same manner as well.

Will the T1 steering bushes (Part No. XRA302990) fit in the bottom of the T2 composite c-hubs? They look similar.

No, the #302290 steel c-hub bushings will not fit T2, you have to get the #302291 ones.

1. #302293 is for T1 cars, #302296 is for T2 cars
2. all T2 cars use same steering block

I suggest you will check the XRAY T1/T2 Quick Reference Table here at http://www.teamxray.com/teamxray/news/n ... egoria=755