XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Center Pulley Bearing https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=419 |
Page 1 of 1 |
Author: | Abam [ Mon Nov 08, 2004 08:16:46 ] |
Post subject: | Center Pulley Bearing |
Author: | Dave Treacy [ Mon Nov 08, 2004 19:00:04 ] |
Post subject: | |
Author: | Tonyv [ Mon Nov 08, 2004 20:28:09 ] |
Post subject: | |
Also make sure there is some side play on the layshaft as ball bearings are not designed to cope with lateral pressure. Also make sure you have the Alu Rear Bulkhead Brace mounted between the rear bulkheads to keep them straight. |
Author: | l150040 [ Tue Nov 09, 2004 09:03:51 ] |
Post subject: | |
Author: | Abam [ Tue Nov 09, 2004 10:46:18 ] |
Post subject: | |
Layshaft checked. OK - no bent found. This one has been check during the first bearing replacement. I will try to check the side play tonite. Shall I put 0.5mm on it? or less? |
Author: | Tonyv [ Tue Nov 09, 2004 15:17:30 ] |
Post subject: | |
Anything between 0.2 and 0.5mm is ok. DonĀ“t go over 0.5. |
Author: | Abam [ Wed Nov 10, 2004 07:12:08 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |