XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
corner speed https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3901 |
Page 1 of 1 |
Author: | T2 SLOW [ Sat Jul 15, 2006 10:49:52 ] |
Post subject: | corner speed |
hi folks i run a t2 in standard set up . rubber tyres on carpet sorex 28 pre built. the car the car seems to dig in and nearly stop in the middle of tight corners. any suggestions on how to make it flow through them better it seems like the rear slides and digs in mid corner. by the way its a monster stock running 17 84 and all screws fitted. cheers |
Author: | Tonyv [ Sat Jul 15, 2006 11:14:13 ] |
Post subject: | |
I suggest you try running harder springs all round first and/or try anti-roll bars front and rear. Usually if the car stops mid-corner it is because the car's setup is too soft. You can also try strengthening the sides of the tyres with some superglue to reduce tyre deformation. |
Author: | T2 SLOW [ Sat Jul 15, 2006 11:49:51 ] |
Post subject: | |
thanks tony will try a spring up all round. reason i asked is nobody seams to move from the silver gold springs in the set up sheets only when on foams. cheers |
Author: | AndyBird [ Tue Sep 12, 2006 22:36:42 ] |
Post subject: | |
Author: | luke T2 [ Tue Sep 12, 2006 23:11:00 ] |
Post subject: | |
i was told that giving your car more ackerman increases corner speed because it allows the outside wheel to turn instead of drag around the corner |
Author: | Tonyv [ Wed Sep 13, 2006 11:18:42 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |