XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Tight diff on FK05 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3688 |
Page 1 of 1 |
Author: | hardrider [ Mon May 29, 2006 12:55:15 ] |
Post subject: | Tight diff on FK05 |
Recently acquired a lightly used FK05... When I start to tighten up to diff, it is a lot tighter than on my FK04. Is this normal for the FK05? I have installed new balls and new plates. Thrust bearing had been replaced to the 2sided copper coloured one. Everything seems to be in order but it's still very tight. Anything else I should be checking or replacing? |
Author: | pucho [ Wed May 31, 2006 15:08:09 ] |
Post subject: | |
Author: | haris [ Wed May 31, 2006 15:37:55 ] |
Post subject: | |
Author: | hardrider [ Thu Jun 01, 2006 12:14:04 ] |
Post subject: | |
Thanks for the replies! Diff was rebuilt conscientiously, taking special care on the washer positions. I think it was properly done. I didn't expect it to be THAT tight! Will run it a little loose on the track to break it in. Let's see how that goes... |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |