XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Plastic Caps For Steering Rod https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=368 |
Page 1 of 1 |
Author: | ben [ Fri Oct 29, 2004 00:09:45 ] |
Post subject: | Plastic Caps For Steering Rod |
Hallo there everyone i have an xray t1 evo2 freedom of choice and am getting fed up of having to pop the plastic ball joints off ![]() ![]() |
Author: | John Reid [ Fri Oct 29, 2004 01:21:22 ] |
Post subject: | |
Its easy, pop off the ball end and drill a hole in the cup big enough for the ball driver to pass through the cup, you can then unscrew the ball without fear of damaging the cup. The size I used is 3mm I think, the mod took only a few minutes with a battery drill. Obviously start by taking the rods off the car and drill them with a flat piece of scrap wood behind them. Wear safety glasses at all times when using power tools. Below is a picture of the front end of my car with the original ball ends which have been modified. [img][img]http://www.jr010a0738.pwp.blueyonder.co.uk/SMTCA/links/ballend.JPG[/img][/img][/url] |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |