XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Help, my brand new belts slip??? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=364 |
Page 1 of 1 |
Author: | Stevemartin [ Thu Oct 28, 2004 00:18:48 ] |
Post subject: | Help, my brand new belts slip??? |
Hi guys, I bought a 2nd have Evo2 freedom of choice, with loads of mods (graphit chassis etc. But since ive had it the belts have slipped. I bought new belts and the gears seem fine, does anyone have any ideas? its the 1.77 ratio. I wanna do carpet wars this sunday but its not looking good. is this a common problem? Thanks for any help Steve |
Author: | John Reid [ Thu Oct 28, 2004 03:32:01 ] |
Post subject: | |
It should just be a matter of tightening the belts up a notch or two on the eccentric cups. It should be in your manual. If you bought it second hand without a manual then you can download one from the Xray web site. |
Author: | PlainOleDave [ Thu Oct 28, 2004 07:01:10 ] |
Post subject: | |
Author: | Stevemartin [ Thu Oct 28, 2004 23:09:17 ] |
Post subject: | |
Im sry im new to this type of car, do all the T1's have the eccentric cams? Thanks for the replies guys |
Author: | Dave Treacy [ Thu Oct 28, 2004 23:24:37 ] |
Post subject: | |
Yes |
Author: | siwoon [ Fri Oct 29, 2004 01:05:22 ] |
Post subject: | eccentric cams |
no, the t1 doesn't have it, only the t1evo2 onwards. |
Author: | John Reid [ Fri Oct 29, 2004 01:10:27 ] |
Post subject: | |
Author: | ldebackker [ Fri Oct 29, 2004 20:19:29 ] |
Post subject: | |
clean your pulleys and belts and set your belts tighter. that'll solve the problem. check if they slip by holding the weels and turn the spur. if they don't slip under force you're fine. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |