XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
New T1R Servo saver binding on suspension holder https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3563 |
Page 1 of 1 |
Author: | oliverro [ Sat May 06, 2006 23:08:36 ] |
Post subject: | New T1R Servo saver binding on suspension holder |
Author: | lardo [ Thu May 11, 2006 12:19:22 ] |
Post subject: | New T1R Servo saver binding on suspension holder |
Author: | teamgp [ Thu May 11, 2006 16:08:13 ] |
Post subject: | |
Unfortunately I don't have any experience with the T1R. Would it be possible for you to provide some pictures of what you are describing? |
Author: | lardo [ Thu May 11, 2006 19:02:51 ] |
Post subject: | New T1R Servo saver binding on suspension holder |
Hello, here is the description from Xray here you can see that it is not possible to mount it higher: The Servo Saver would not pass if you mount one or two holes higher, kind regards Lars [/img] |
Author: | Gizmo [ Thu May 11, 2006 23:38:19 ] |
Post subject: | |
Author: | littleal [ Fri May 12, 2006 09:38:36 ] |
Post subject: | |
We had a T1R, about 2 years ago before we moved up through the range and now have a T2. From the photo, it looks like the servo saver is in upside down unless they have been modified, which I don't think that they have. Can you take a clearer photo to confirm please?. The bulkheads look like FK04 bulkheads, which we ran on our T1R towards the end, but they really are meant for short arms, maybe this is part of the problem?. Maybe Mario could shed a little light?. Hope this helps Phil |
Author: | shortcut [ Fri May 19, 2006 10:18:25 ] |
Post subject: | same problem |
Same problem here. Rebuilt it using the lowest hole. Now works fine. Greetz |
Author: | drewdc [ Fri May 19, 2006 12:11:15 ] |
Post subject: | |
You could try using a shorter screw and shave a bit of plastice off the servo saver, that way you can use the anti-dive. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |