New T1R Servo saver binding on suspension holder

teamgp · **Posted:** Thu May 11, 2006 16:08:13

Unfortunately I don't have any experience with the T1R. Would it be possible for you to provide some pictures of what you are describing?

lardo · **Posted:** Thu May 11, 2006 19:02:51

Hello,

here is the description from Xray

here you can see that it is not possible to mount it higher:

The Servo Saver would not pass if you mount one or two holes higher,

kind regards

Lars

[/img]

Gizmo · **Posted:** Thu May 11, 2006 23:38:19

littleal · **Posted:** Fri May 12, 2006 09:38:36

We had a T1R, about 2 years ago before we moved up through the range and now have a T2. From the photo, it looks like the servo saver is in upside down unless they have been modified, which I don't think that they have. Can you take a clearer photo to confirm please?. The bulkheads look like FK04 bulkheads, which we ran on our T1R towards the end, but they really are meant for short arms, maybe this is part of the problem?. Maybe Mario could shed a little light?.
Hope this helps
Phil

shortcut · **Joined:** Fri May 19, 2006 10:15:14 **Posts:** 1

Same problem here.

Rebuilt it using the lowest hole. Now works fine.

Greetz

drewdc · **Posted:** Fri May 19, 2006 12:11:15

You could try using a shorter screw and shave a bit of plastice off the servo saver, that way you can use the anti-dive.

XRAY - Model racing cars

New T1R Servo saver binding on suspension holder

Who is online