XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Setup sheet question https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3560 |
Page 1 of 1 |
Author: | new92 [ Fri May 05, 2006 14:26:11 ] |
Post subject: | Setup sheet question |
I KNOW this has been talked about but a search pulled up everything under the sun and I didnt have time to read through all of the posts again. On the setup sheets for the bottom of the chassis the red dots are where screws have been removed for flex right? And the dot for the servo saver indicates where the bearing is not the tab right? Thanks. |
Author: | Frans H [ Fri May 05, 2006 15:00:11 ] |
Post subject: | |
yes: the red dots are marked like you said. The servo saver position is for or rearward and that one is marked 1 or 2 ( one for front and 2 for ehhhh back ) |
Author: | teamgp [ Fri May 05, 2006 15:02:03 ] |
Post subject: | |
Author: | new92 [ Fri May 05, 2006 15:28:19 ] |
Post subject: | |
Author: | Tonyv [ Fri May 05, 2006 15:44:34 ] |
Post subject: | |
Author: | new92 [ Fri May 05, 2006 16:31:28 ] |
Post subject: | |
Author: | Frans H [ Fri May 05, 2006 16:32:19 ] |
Post subject: | |
Author: | Tonyv [ Fri May 05, 2006 16:44:40 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |