| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Servo Fitment T2 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3316 |
Page 1 of 1 |
| Author: | AndyBird [ Mon Mar 27, 2006 17:35:29 ] |
| Post subject: | Servo Fitment T2 |
Hi, has anyone fitted an S3305 (*fut) servo to a T2. I have used the arm supplied in the kit and the steel shims, but the screw still hits the chassis. Any ideas ? |
|
| Author: | SuperXRAY [ Mon Mar 27, 2006 17:51:25 ] |
| Post subject: | |
What do you mean hits the chassis? The servo mounts screw onto the chassis and the servo screws onto the servo mounts, so after looking at mine I can't see any screws that could hit the chassis? Please explain... |
|
| Author: | AndyBird [ Mon Mar 27, 2006 18:14:05 ] |
| Post subject: | |
Hi, sorry it the screw on the end of the arm that catches the top deck of the chassis. It's as if the servo is not sitting far enough away from the centre of the car. I have a 625MG on at the moment and that works fine. But I find the ft3305 is a smoother servo and centrers back better to a central position |
|
| Author: | ALBERTO [ Mon Mar 27, 2006 18:48:06 ] |
| Post subject: | |
ya gunna need to mount the servo further away from the center of the car.. I use a 9402 fut servo and used almost 4mm of spacers, as to prevent the servo arm from hitting the top deck |
|
| Author: | SuperXRAY [ Mon Mar 27, 2006 21:16:30 ] |
| Post subject: | |
| Author: | drewdc [ Wed Mar 29, 2006 11:25:35 ] |
| Post subject: | |
I mounted the steering link on the other side of the servo horn, you have to use a different horn but you can mount the servo with out using shims or filling the top deck. |
|
| Author: | ALBERTO [ Wed Mar 29, 2006 17:42:34 ] |
| Post subject: | |
| Author: | SuperXRAY [ Thu Mar 30, 2006 03:24:22 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|