XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Alu Uprights (T2) https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=3219 |
Page 1 of 1 |
Author: | Joep [ Fri Mar 10, 2006 21:09:06 ] |
Post subject: | Alu Uprights (T2) |
Just got my Two questions: 1) Why are the bearings smaller than the standard ones? 2) What is the item number of these smaller bearings? Thanks in advance.. AND watch out with downstop settings. You should add 1 mm to the downstop value with composite uprights to apply for alu ones. Added after reading the manual: This applies only when you meassure under the upright. BUT you should meassure under the arm. |
Author: | mario [ Sat Mar 11, 2006 14:45:08 ] |
Post subject: | Re: Alu Uprights (T2) |
Author: | Erikderaaf [ Sat Mar 11, 2006 16:06:12 ] |
Post subject: | |
Author: | Joep [ Sat Mar 11, 2006 16:11:26 ] |
Post subject: | |
Author: | Frans H [ Sat Mar 11, 2006 21:00:06 ] |
Post subject: | |
Author: | Joep [ Sat Mar 11, 2006 21:24:49 ] |
Post subject: | |
Author: | hugovdb [ Sat Mar 11, 2006 23:24:53 ] |
Post subject: | |
Author: | Joep [ Sat Mar 11, 2006 23:59:55 ] |
Post subject: | |
Author: | mario [ Fri Mar 17, 2006 17:52:56 ] |
Post subject: | |
Author: | Joep [ Fri Mar 17, 2006 19:29:58 ] |
Post subject: | |
Author: | teamgp [ Fri Mar 17, 2006 19:41:23 ] |
Post subject: | |
Author: | mario [ Fri Mar 17, 2006 19:53:14 ] |
Post subject: | |
Author: | Joep [ Sat Mar 18, 2006 17:39:47 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |