XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
changing a t1r to a graphite chassis https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=300 |
Page 1 of 1 |
Author: | timonator [ Tue Oct 19, 2004 01:32:51 ] |
Post subject: | changing a t1r to a graphite chassis |
Author: | brano [ Tue Oct 19, 2004 06:24:18 ] |
Post subject: | |
Every graphite chassis and graphite top deck come with #302551-eccentric servo saver plastic cover. Press the #302551 eccentric servo saver plastic cover into the corresponding hole in the chassis. Orient the cover so the tab fits in the notch on the right side of the chassis. See the illustration for the proper location and than insert a #309010 (BB 4x7) ball-bearing into the plastic cover. Press the #302551 eccentric servo saver bearing plastic cover into the hole in the upper deck as shown. Orient the cover so the tab fits in the notch on the right side of the upper deck. See the illustration for the proper orientation. Place the #309010 (BB 4x7) ball-bearing in the plastic cap. Mount the #306300 antenna holder in an available position, depending on the position of the receiver. (I am sorry but I have found only pictures from EVO2) |
Author: | timonator [ Tue Oct 19, 2004 13:02:47 ] |
Post subject: | |
Author: | John Reid [ Thu Oct 21, 2004 13:12:15 ] |
Post subject: | Re: changing a t1r to a graphite chassis |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |