XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Getting the 180mm belt on with the 1.77 low ratio https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=2778 |
Page 1 of 1 |
Author: | Paul da Graca [ Fri Dec 30, 2005 10:21:48 ] |
Post subject: | Getting the 180mm belt on with the 1.77 low ratio |
Author: | chisholm [ Fri Dec 30, 2005 17:59:40 ] |
Post subject: | Re: Getting the 180mm belt on with the 1.77 low ratio |
Author: | ChrisP [ Fri Dec 30, 2005 18:40:33 ] |
Post subject: | |
Author: | Tonyv [ Sat Dec 31, 2005 21:29:47 ] |
Post subject: | |
Paul, did you change both the lay shaft pulleys AND the pulleys on the front and rear diff? The diff pulleys should be 32 with the low ratio set, but if you still have the 34 teeth diff pulleys the belts will not fit. |
Author: | Paul da Graca [ Tue Jan 03, 2006 10:41:28 ] |
Post subject: | |
Author: | Mark Christopher [ Tue Jan 03, 2006 11:43:06 ] |
Post subject: | |
Author: | Paul da Graca [ Tue Jan 03, 2006 11:46:08 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |