XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Xray T4 camber links https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=27231 |
Page 1 of 1 |
Author: | Boris [ Wed Feb 21, 2018 23:58:32 ] |
Post subject: | Xray T4 camber links |
Hello. I have a question about the length of the camber links of my T4. I use a setup station to precisely measure the camber.When the station shows equal angles left to right, the actual length of the links is not the same. The biggest difference I measured is around 0.5mm. Does anyone have this problem or this is normal? I presume that I didn't screw perfectly horizontally the plastic ends of the link so maybe the error comes from there but I am not sure. I also would like to know if you even check the length of the links after you adjust the desired camber on the setup station or you just leave it as it is without checking. Thanks in advance! |
Author: | robbie dodge [ Thu Mar 15, 2018 20:25:53 ] |
Post subject: | Re: Xray T4 camber links |
Others may disagree but I personally don't worry too much about the length of the camber links. Mine are usually off probably 1/4 to 1/2 turn each side IIRC. I think if you are about 0.5mm off that is fine. The only time I really worry about the link length is on the steering links. I do make an effort to keep them within 0.1mm of each other at all times. You may want to make sure there are no mold flashings on the ballcups that are giving you a false reading. Just remove them carefully with a sharp xacto. |
Author: | Boris [ Wed Mar 28, 2018 21:55:51 ] |
Post subject: | Re: Xray T4 camber links |
Thanks Robbie! |
Author: | Nancy56 [ Fri Jun 07, 2019 09:55:23 ] |
Post subject: | Re: Xray T4 camber links |
Author: | jamuns [ Thu Jul 25, 2019 21:27:42 ] |
Post subject: | Re: Xray T4 camber links |
Thanks, Robbie for creating this wonderful thread. Checking the whole discussions and I should agree with that first comment ![]() Thank You, . |
Author: | DavidLangston [ Fri Jul 26, 2019 13:36:11 ] |
Post subject: | Re: Xray T4 camber links |
Thanks robbie for this Great information. I was checking constantly this post and I am impressed! Very helpful information. I care for such information a lot. I was looking for this particular info for a very long time. Thank you and best of luck. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |