T1 evo2 height???

myk505 · **Joined:** Mon Apr 25, 2005 10:11:31 **Posts:** 4

There is no way that i can get the chasis that low (4mm) 7mm is what I get, where am i going wrong, If I take the measurement from the rear it is 7mm, If i take the ride height on the side of the chasis just in front of the rear tires I get 5mm, The spring pre-load on the shock is backed off all the way, Any suggestions most welcome. :roll:

Goonish · **Posted:** Mon Oct 10, 2005 10:11:33

Take your measurements from the extreme front and rear of the chassis. That's where it matters most. I believe the XRAY setup guide covers this nicely, IIRC.

What shock towers are you using? On my original T1 and the Evo2 with an ultratune shock tower I can get both of the chassis to bottom out.

XRAY - Model racing cars

T1 evo2 height???

Who is online