| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| T1 evo2 height??? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=2362 |
Page 1 of 1 |
| Author: | myk505 [ Sat Oct 08, 2005 10:21:27 ] |
| Post subject: | T1 evo2 height??? |
| Author: | drewdc [ Sat Oct 08, 2005 12:47:19 ] |
| Post subject: | |
| Author: | Goonish [ Sat Oct 08, 2005 23:01:37 ] |
| Post subject: | |
| Author: | myk505 [ Mon Oct 10, 2005 10:07:41 ] |
| Post subject: | |
There is no way that i can get the chasis that low (4mm) 7mm is what I get, where am i going wrong, If I take the measurement from the rear it is 7mm, If i take the ride height on the side of the chasis just in front of the rear tires I get 5mm, The spring pre-load on the shock is backed off all the way, Any suggestions most welcome. 
|
|
| Author: | Goonish [ Mon Oct 10, 2005 10:11:33 ] |
| Post subject: | |
Take your measurements from the extreme front and rear of the chassis. That's where it matters most. I believe the XRAY setup guide covers this nicely, IIRC. What shock towers are you using? On my original T1 and the Evo2 with an ultratune shock tower I can get both of the chassis to bottom out. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|