XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Changing Caster ? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=2349 |
Page 1 of 1 |
Author: | Scotty [ Wed Oct 05, 2005 15:23:51 ] |
Post subject: | Changing Caster ? |
Author: | RC Infusion.com [ Wed Oct 05, 2005 15:38:47 ] |
Post subject: | Re: Changing Caster ? |
Author: | teamgp [ Wed Oct 05, 2005 16:32:53 ] |
Post subject: | |
Scotty is correct. For more information, check out pages 44 and 45 of the . |
Author: | Eyeball [ Thu Oct 06, 2005 03:52:59 ] |
Post subject: | |
What kind of caster would you recommend on a fast smooth asphalt track with a good amount of grip. The track has some really fast corners and some slow sharp ones too. I'm currently using 3 deg caster. Thanks, S |
Author: | teamgp [ Thu Oct 06, 2005 15:11:14 ] |
Post subject: | |
Author: | RC Infusion.com [ Thu Oct 06, 2005 15:13:10 ] |
Post subject: | |
Author: | darren styles [ Thu Oct 06, 2005 23:43:53 ] |
Post subject: | |
eyeball, try running 3 degree"s of caster with a small amount of kick up (use a 0.75 holder) on the rear of the front wishbone pivots, this will make the car steer well enough at low speed, but easier to drive at high speed. |
Author: | fulcrum2 [ Fri Oct 07, 2005 22:43:12 ] |
Post subject: | |
Darren, what is a 0,75 holder? Are you tryin´to mount the front holder lower than the rear holder of the front wishbone? |
Author: | darren styles [ Fri Oct 07, 2005 23:23:32 ] |
Post subject: | |
by 0.75 holder i mean the optional pivot blocks for the suspension to lower roll centre, by placing this on the rear mount for the front wishbone you get a slight angle on the arm. |
Author: | Eyeball [ Sat Oct 08, 2005 05:50:31 ] |
Post subject: | |
Author: | darren styles [ Sat Oct 08, 2005 08:15:28 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |