XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
preventing damage to out drives https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=233 |
Page 1 of 1 |
Author: | mattup [ Sat Oct 09, 2004 10:42:06 ] |
Post subject: | preventing damage to out drives |
What is the best way of limiting the steering angle so as to stop the drive shaft contacting the out drive? |
Author: | Tonyv [ Sat Oct 09, 2004 14:34:30 ] |
Post subject: | |
Best way is to use the EPA setting on your transmitter. |
Author: | mindrev [ Sat Oct 09, 2004 15:25:07 ] |
Post subject: | |
If you use foam tires on carpet the current spring is way too soft. Even without hitting the boards the aluminum outdrives will be destroyed and the shaft will be badly marked. You can replace the spring in the servo saver with a harder one or you can glue the servo saver and use one stronger on the servo. You can also screw a ballstud underneath the steering block in the first hole, cover it with silicon fuel line and carefully adjust the EPA. |
Author: | l150040 [ Mon Oct 11, 2004 08:05:28 ] |
Post subject: | |
I have glued little rubber patches (thickness 2-3 mm) behind c-hubs. These prevents steering blocks to turn too much. I also use the EPA setting on my transmitter. |
Author: | Peter Szuhai [ Mon Oct 11, 2004 09:44:44 ] |
Post subject: | |
Author: | nnick [ Tue Oct 12, 2004 12:19:08 ] |
Post subject: | |
Author: | mindrev [ Tue Oct 12, 2004 15:11:53 ] |
Post subject: | |
Hi Nick, I put some images If you do something like this you must check regularly the silicon because it gets destroyed. Mike |
Author: | nnick [ Wed Oct 13, 2004 15:19:59 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |