XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
steer from the rear :) https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=2326 |
Page 1 of 1 |
Author: | Barkley Abernethy [ Sun Oct 02, 2005 12:10:00 ] |
Post subject: | steer from the rear :) |
although this is fun it doesnt give a good run time .....my car when im entering the corner off power flings the tail out on power entry isnt as bad but its a case of power sliding ...with the ride height at 6 i noticed the rear suspension was very hard the ball joint was lying ontop of the rear upright so i had to put a spacer of 2mm between the joint and the hub to give me suspension travel is this normal ? it aint in the instruction book when building it ......the rear diff is fine nice and smooth i played with droop ,shock postion ,springs ,roll centre and rear anti dive nothing worked any help would be great we are racing indoors on polished wooden floors |
Author: | teamgp [ Mon Oct 03, 2005 15:32:33 ] |
Post subject: | |
Its hard to say unless you post your full setup in the Setup Sheet section for us to see. I use 2mm shims to space out my lower shock ball ends from the arm without any problems. I do this to get a better angle for the shock though as I use the inner holes on the arm. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |