XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Setting downstop screws on T1FK-05 front arms https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=2034 |
Page 1 of 1 |
Author: | Alpal [ Sun Jul 31, 2005 11:46:55 ] |
Post subject: | Setting downstop screws on T1FK-05 front arms |
Author: | chaz [ Sun Jul 31, 2005 20:00:11 ] |
Post subject: | Re: Setting downstop screws on T1FK-05 front arms |
Author: | teamgp [ Mon Aug 01, 2005 17:36:27 ] |
Post subject: | |
Author: | Alpal [ Tue Aug 02, 2005 10:08:07 ] |
Post subject: | |
Gidday teamgp, The screw is in the hole closest to the bulkhead. By the way, I have converted to XRAY from a Schumacher Mi2. I am extremely impressed with the oustanding quality of the FK05 kit; well worth the investment. Can't wait to get it on the track and start driving. Cheers, Alpal. |
Author: | MarkG [ Tue Aug 02, 2005 11:38:59 ] |
Post subject: | Front droop |
The droop can be measured from the bottom of the chassis to the underside of the screw at the c-hub. This should be set at 1mm. If you haven't got droop measuring blocks, just place your chassis on a flat surface with no wheels on, and measure under the screw with a ride height guage. Just make sure the chassis is completely flat and not sitting up on a screw head. Hope this helps Mark |
Author: | Alpal [ Tue Aug 02, 2005 12:35:44 ] |
Post subject: | |
Gidday Mark, Thanks for the advice. I've got a ride height gauge and when I checked it there was just over 3mm between bottom of chassis and C hub after assembling according to the manual. Setting it at 1mm using your method looks and feels much more like the correct setting. Thanks again to everyone for all the help, much appreciated. Cheers, Alpal. |
Author: | teamgp [ Tue Aug 02, 2005 18:49:49 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |