XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4 '17 Missing holes https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=19416 |
Page 1 of 1 |
Author: | chairman [ Wed Oct 26, 2016 21:07:13 ] | ||
Post subject: | T4 '17 Missing holes | ||
Hi, today I build my T4 '17. I think it is a very good car. But I found a mistake. The holes for the plastic nuts for battery backstop are missing. In the manual said that the nuts should screwed in the holes for the "flex chassis adjustment" but the holes of the "flex chassis adjustment" aren't helpful because then the nuts behind the belt have no function. ![]() I hope you have idea to solve the problem.
|
Author: | Jan [ Thu Oct 27, 2016 08:57:43 ] |
Post subject: | Re: T4 '17 Missing holes |
Hi Chairman, sorry for the mistake in the instruction manual. It's going to be shortly corrected. You can follow the tip shown on page 35 in step one to adjust the battery position. |
Author: | marco.m [ Thu Oct 27, 2016 21:46:28 ] |
Post subject: | Re: T4 '17 Missing holes |
Author: | Skiddins [ Fri Oct 28, 2016 10:33:41 ] |
Post subject: | Re: T4 '17 Missing holes |
Author: | Carnage9270 [ Mon Oct 31, 2016 21:03:29 ] |
Post subject: | Re: T4 '17 Missing holes |
I cut up an old bulkhead (thicker CF) and glued it to the chassis up against the motor plate (used a small spacer to create a slight gap, which I removed after it dried). Works very well. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |