XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4 Motor Mount https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=19165 |
Page 1 of 1 |
Author: | Oldtimeracer [ Mon Nov 09, 2015 15:36:26 ] |
Post subject: | T4 Motor Mount |
We run a class called Scale TC which is for scale looking body shells. One of the rules is running a brushed, fixed timing motor ( we run this class indoors mainly to keep speeds down and limit damage with less experienced racers). However with the fixed timing motors there are only two opposing motor screw holes so cannot use them in the T4 as it has only the two lower motor holes which do not exist on the fixed timing motors. My question is....is there an alternative motor mount that can be used in the T4 to allow the use of these fixed timing motors? |
Author: | coastal [ Mon Nov 09, 2015 21:23:19 ] |
Post subject: | Re: T4 Motor Mount |
No - none available. |
Author: | beale [ Mon Nov 09, 2015 22:36:37 ] |
Post subject: | Re: T4 Motor Mount |
Think this question has been asked enough times to warrant a spacer for silver can's, I just opened a can and drill/tapped M3 because I have the kit available but a spacer with correct threaded holes and clearance holes would be a good addition to the options list |
Author: | Oldtimeracer [ Tue Nov 10, 2015 10:41:54 ] |
Post subject: | Re: T4 Motor Mount |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |