XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Bottom Shock pivot balls https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=19148 |
Page 1 of 1 |
Author: | aktug78 [ Mon Oct 12, 2015 22:41:36 ] |
Post subject: | Bottom Shock pivot balls |
Hi all, When install the bottom pivot balls of shocks while shiny Side is out, doesnt move freely! Is it normal? Regards |
Author: | Skiddins [ Tue Oct 13, 2015 10:29:08 ] |
Post subject: | Re: Bottom Shock pivot balls |
Try removing the ball and putting it back in. If that doesn't work try polishing the pivot ball with some very fine sandpaper. 1500 grit etc. |
Author: | aktug78 [ Tue Oct 13, 2015 11:19:11 ] |
Post subject: | Re: Bottom Shock pivot balls |
Thank You Skiddins. |
Author: | aktug78 [ Tue Oct 13, 2015 15:43:34 ] |
Post subject: | Re: Bottom Shock pivot balls |
Author: | Olly Jefferies [ Tue Oct 13, 2015 17:07:35 ] |
Post subject: | Re: Bottom Shock pivot balls |
Hi, Sometimes when screwing the eyelet onto the shock shaft you can tighten it too much, this means the shaft puts pressure onto the eyelet that the ball fits into. Loosen the eyelet a little and see if it helps. Oj |
Author: | aktug78 [ Wed Oct 14, 2015 12:18:48 ] |
Post subject: | Re: Bottom Shock pivot balls |
Author: | aktug78 [ Fri Oct 16, 2015 10:11:57 ] |
Post subject: | Re: Bottom Shock pivot balls |
Author: | aktug78 [ Sun Oct 18, 2015 22:17:44 ] |
Post subject: | Re: Bottom Shock pivot balls |
Thank You Olly, fixed now |
Author: | aktug78 [ Sun Oct 18, 2015 22:17:53 ] |
Post subject: | Re: Bottom Shock pivot balls |
Thank You Olly, fixed now |
Author: | Olly Jefferies [ Mon Oct 19, 2015 13:23:45 ] |
Post subject: | Re: Bottom Shock pivot balls |
Great ![]() |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |