Hi guys Helping a friend with his xray t3'11 And a major issue I have is that the car is not getting enough steering The car isn't on an old 11 chassis, so is down the middle of the car between the top deck The issue I think is in the steering bell cranks The 11 has one bell crank that has the additional side piece, to join the servo, but when it goes forward it locks out on the car, meaning the EPA is low and worse then the other side of the car Also the steering is getting nowhere near full, when I try to do the EPA, the steering block gets no where near the c hub
The servo saver is in the middle, at a right angle. Which I thouht would be correct, unless I need to set it differently on this car
Any help appreciated
Attachments: |
image.jpg [ 145.75 KiB | Viewed 3280 times ]
|
|