| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Xray T4 2015 Assembling Questions https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=18926 |
Page 1 of 1 |
| Author: | Tak [ Mon Dec 29, 2014 10:06:46 ] |
| Post subject: | Xray T4 2015 Assembling Questions |
Hello. I have just finished the assembly of this fantastic model and I have two questions: 1) When I assembled the shock shafts to the 4-hole 1.1mm pistons and inserted them into the alu shock body, I found that there is a lot of play. The pistons do not fit exactly into the shock body (the body is way bigger than the pistons) and at the final assembly the hole piston goes back and forth. Is this normal? 2) The upper bumper holder (part No 301216) has about 1-2mm gap from the alu front bulkheads. Is this my fault or is it disigned like this. In a serious crash I have a feeling that the chassis would brake. Takis. |
|
| Author: | spotlessdragon [ Mon Dec 29, 2014 16:30:54 ] |
| Post subject: | Re: Xray T4 2015 Assembling Questions |
the small gap between the bumper brace and bulkhead is normal as for the shox mine were the same but they work fine |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|