XRAY - Model racing cars

Hello.
I want to try the front inboard toe out (arm sweep) on my car.
I have read that i should put 0.5 shim each side at the ff blocks....Correct???
Also i have to take out the 1.0mm shim at the ackermann or not with the front inboard toe out ???

One last thing.... What is the effect of the rear hub with 1° degree toe-in

Thanks!!!

Yep that's correct, add 0.5mm to the FF hangers. That's pretty much the standard setup on the T4.

I'd leave the ackerman shim in to start with so you can feel what the arm sweep does.

No one ever runs outboard toe on the rear, so I don't think you'll get an answer to that one!

Thanks i will try it.......
About rear hub i want to say 1 degree toe in my mistake.(I edit)