XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4'14 Drive Shaft issues https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=18617 |
Page 1 of 1 |
Author: | ChrissieL17 [ Wed Apr 02, 2014 21:53:34 ] |
Post subject: | T4'14 Drive Shaft issues |
Hi has anyone had any issues with dog bones breaking on the T4'14? I've broken a rear one and two ecs dog bones (in consecutive races!) all under power i.e. not as a result of a crash. I've had a T3 and 2 T4's before and never had an issue. Chris |
Author: | beale [ Wed Apr 02, 2014 22:34:29 ] |
Post subject: | Re: T4'14 Drive Shaft issues |
Just out of interest what surface, motor and tyre combination? |
Author: | ChrissieL17 [ Wed Apr 02, 2014 23:48:04 ] |
Post subject: | Re: T4'14 Drive Shaft issues |
Author: | Skiddins [ Thu Apr 03, 2014 02:00:09 ] |
Post subject: | Re: T4'14 Drive Shaft issues |
Have you used the grub screws and put them in too tight? This could bend the pins slightly and stress them which can cause them to break very easily. If this is the case try using heatshrink instead of the grub screws; I've used this on all my ECS style driveshafts and have never had a failure, just a few bent dogbones Skiddins |
Author: | ChrissieL17 [ Thu Apr 03, 2014 23:54:47 ] |
Post subject: | Re: T4'14 Drive Shaft issues |
Cheers D but that's not it. They are breaking above the pin. It's where the dog bone meets the trinnion. |
Author: | Skiddins [ Fri Apr 04, 2014 01:06:46 ] |
Post subject: | Re: T4'14 Drive Shaft issues |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |