We switched to open mod this past Saturday and the increased cornering speed in large sweepers had the tires wearing the outside edges too much. So I increased the static camber all around by .5d before the A main and the grip was there. Only problem I had then, was the springs must have been too soft with the increased grip and I dragged the edge of my chassis every lap in the large sweeper. Once the main was over (took 3rd), I ran an additional 8 laps. Of course I must have been pretty well undergeared, since I was running an Orion V2 12x2 with packs charged at 6.2 amps (forgot to change from stock charge settings). But I also realized that I had way too much steering throw on the M8 and I was dragging the inside wheel in tight corners due to the maximum ackerman setting.
All this being said, if anyone tries the stock/19t rubber/asphalt setup I've posted in a mod class, I can only guess right now that you should make the following changes:
* Increase camber .5d on all four wheels
* Either:
- Use dark blue (25lb) front springs & light blue (20lb) rear springs
or
- Raise ride height by .5mm to 6mm front and 6.5mm rear
Ole,
I've PM'd you to get your email address.
|
)
