XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Rear Toe in problems https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=1771 |
Page 1 of 1 |
Author: | drewdc [ Thu Jun 09, 2005 08:05:49 ] |
Post subject: | Rear Toe in problems |
I've previously bought a T1R from one of the guys form my local track and the cars been great. The only problems is that I've found a problem with the rear toe in. In the instructions it says that with no clips in the rear arms the car should have 3 decrease toe in. When I have no clips on the rear arms of my car it has 0 decrease toe. What could be the reson for this. Thanks, Drew. |
Author: | Frans H [ Thu Jun 09, 2005 09:46:50 ] |
Post subject: | |
check it with the instruction manuel. I think you have taken the numbered pin holders in the wrong position. The small one has to be in front and the large one in the rear ( at the inside off the bulkhead ) If you don't have the std pin holders, but the one's with the alu inside then you have to put a ....mm shim at the rear pin holder to create the toe in. By using a 1 mm shimm you will have 1 degree toe in and so on. hopes this helps. Frans |
Author: | drewdc [ Thu Jun 09, 2005 10:12:51 ] |
Post subject: | |
I looked on the instruction manual again and it says that the wide pin holder should go infront of the arm and the narrow pin holder behind. I didn't build the car so i didn't know this until now. I looked on my car and it has a narrow pin holder hehind and infront of the rear arm so i would have to get hold of some wide pin holders or get more clips to add on the front pin holders. Thanks for the reply it has been alot of help. Drew. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |