Joined: Tue Sep 14, 2004 23:03:21 Posts: 227 Location: Schiedam, the Netherlands
|
check it with the instruction manuel. I think you have taken the numbered pin holders in the wrong position. The small one has to be in front and the large one in the rear ( at the inside off the bulkhead )
If you don't have the std pin holders, but the one's with the alu inside then you have to put a ....mm shim at the rear pin holder to create the toe in. By using a 1 mm shimm you will have 1 degree toe in and so on.
hopes this helps.
Frans
|
|