| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| The old ball pivot system. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=160 |
Page 1 of 1 |
| Author: | symon [ Sun Sep 26, 2004 22:29:39 ] |
| Post subject: | The old ball pivot system. |
I'm using an old Evo2 which has ball pivot steering. I recently ripped off the right wheel at high speed on a low wall. I bought the left and right steering blocks but the silver hex hub that holds the wheels on to the car does not fit all the way through the steerer block. Is there a different hex hub size now? and if there is a new sized hex hub do I need to change the length of my front dog bones to make every thing fit? Also anyone got any good cheap ideas on how to get some dodgy screws out of the Evo? |
|
| Author: | John Reid [ Mon Sep 27, 2004 03:13:59 ] |
| Post subject: | |
The axle and hub design changed to use the same axles front and rear on the EVO. The original car had shorter front axles and longer wishbones and drive shafts. sounds like you have an original style axle on a new hub. Try exchanging the axle at the shop. Or you always try flogging it on Ebay. To be honest, the best option for you would be to buy the C hub conversion pack. |
|
| Author: | John Reid [ Mon Sep 27, 2004 03:16:42 ] |
| Post subject: | |
For screws look here |
|
| Author: | brano [ Mon Sep 27, 2004 06:43:03 ] |
| Post subject: | Re: The old ball pivot system. |
| Author: | Griff [ Mon Sep 27, 2004 08:11:09 ] |
| Post subject: | |
| Author: | symon [ Mon Sep 27, 2004 09:05:37 ] |
| Post subject: | |
| Author: | Griff [ Mon Sep 27, 2004 15:58:44 ] |
| Post subject: | |
| Author: | ALBERTO [ Mon Sep 27, 2004 16:13:00 ] |
| Post subject: | |
| Author: | Tonyv [ Mon Sep 27, 2004 17:30:50 ] |
| Post subject: | |
| Author: | symon [ Mon Sep 27, 2004 18:58:25 ] |
| Post subject: | |
| Author: | Dave Treacy [ Mon Sep 27, 2004 18:59:51 ] |
| Post subject: | |
| Author: | ALBERTO [ Tue Sep 28, 2004 15:55:21 ] |
| Post subject: | |
| Author: | John Reid [ Sat Oct 16, 2004 00:16:27 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|