| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| GP3700 Chassis modification https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=1408 |
Page 1 of 1 |
| Author: | John Thornhill [ Thu Apr 14, 2005 20:15:37 ] |
| Post subject: | GP3700 Chassis modification |
| Author: | ldebackker [ Thu Apr 14, 2005 21:09:21 ] |
| Post subject: | |
| Author: | G30RGE [ Thu Apr 14, 2005 21:50:17 ] |
| Post subject: | |
| Author: | mario [ Thu Apr 14, 2005 22:24:49 ] |
| Post subject: | |
| Author: | Designer01 [ Tue Apr 19, 2005 20:58:58 ] |
| Post subject: | |
Maybe a bit off topic, but does anyone have charge setup for the GP3700 Cells? I am using a Much More Cellmaster... Thanks |
|
| Author: | Joep [ Tue Apr 19, 2005 21:37:40 ] |
| Post subject: | |
Its not 3700 but 3600 what I found on a Japanese site: CTX-CHG Intellect 3600 non matched • 1/3 3100mAh > 6.5A > Flex-no • 2/3 3120mAh > 0.1A > Flex-no • 3/3 3900mAh > 5.2A > delta peak 12mV , temp cut 48C • Repeak x2 > delay 5:00 > Repeak capacity limit 250mAh I think you have to play a little with the settings to adjust it to 3700 and find what give the best performance. Did not try it yet ...... only 3300 here in my car.... BTW: What a terrific charger BTW. Got it just a week 
|
|
| Author: | Dave Treacy [ Tue Apr 19, 2005 21:46:21 ] |
| Post subject: | |
Mario wrote: "Posted: Thu Apr 14, 2005 8:24 pm Post subject: -------------------------------------------------------------------------------- I hope to have the Tech Tip published tomorrow. It will be added to the FAQ section. " I've had a shufty at the FAQ and the instructions Mario was planning to post on the 15th are still not there... Any idea how long until the modification is published? It's the first round of the BRCA nationals this weekend and my son will run 3700's if there is a easy way of getting them to fit... I have them loose in boxes ready to make up AFTER I've checked the chassis modification works, so time is of the essence. I just hope that the modification doesn't reduce the structural integrity of the chassis...imagine filing away to get the cells to fit and one bump and your chassis is in 2 pieces... 
|
|
| Author: | mario [ Tue Apr 19, 2005 21:49:50 ] |
| Post subject: | |
It is very busy right now with finishing the XB8R project. The text is ready, tomorrow the pictures and it can go online. It is very easy though, just few slots have to be slightly increased. But anyway, I will try to post tomorrow. |
|
| Author: | jersey [ Fri Apr 22, 2005 02:10:56 ] |
| Post subject: | |
| Author: | mario [ Fri Apr 22, 2005 09:27:16 ] |
| Post subject: | |
Today in the FAQ thread. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|