XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Spring steel front hubs https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=140 |
Page 1 of 1 |
Author: | redlinezak [ Thu Sep 23, 2004 17:25:23 ] |
Post subject: | Spring steel front hubs |
just wondering if anyone uses these i have seen that a few of the team drivers seem to and was wondering if the benefit of them not wearing outwieghs the downside of their weight. Is there going to be any noticable difference in performance with the increased drivetrain weight? Thanks Nathan |
Author: | 1jag8 [ Thu Sep 23, 2004 18:58:29 ] |
Post subject: | |
I switched to the steel hubs on my FK because the aluminum hubs will expand with use and be difficult to get through the bearings. I don't think there's a wear issue and you'll never notice the weight difference. |
Author: | John Reid [ Fri Sep 24, 2004 00:35:53 ] |
Post subject: | |
If you run indoors or on a track with hard edge markings they are worth getting for the front end. The rear end isnt normally a problem but worth betting if you want to bullet proof your car. I preffer the look of them over the alloy and the difference in weight is negligible. |
Author: | JKA [ Fri Sep 24, 2004 06:19:13 ] |
Post subject: | |
Author: | Michal101 [ Fri Sep 24, 2004 07:24:21 ] |
Post subject: | |
Author: | brano [ Fri Sep 24, 2004 07:37:28 ] |
Post subject: | |
Author: | Michal101 [ Fri Sep 24, 2004 07:40:46 ] |
Post subject: | |
Author: | Andreas Myrberg [ Fri Sep 24, 2004 14:22:40 ] |
Post subject: | |
Author: | ianp [ Sat Sep 25, 2004 01:04:03 ] |
Post subject: | |
hi boyz, can you tell me the difference between the two 305215 and 305315, i have a t1r and have got some 215s that were given to me. ian |
Author: | brano [ Mon Sep 27, 2004 07:07:02 ] |
Post subject: | |
Author: | ianp [ Mon Sep 27, 2004 10:40:55 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |