XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4'14 Setup Sheet Question https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13688 |
Page 1 of 1 |
Author: | Skiddins [ Wed Oct 02, 2013 14:17:12 ] |
Post subject: | T4'14 Setup Sheet Question |
Looking at the new setup sheets for the T4'14, what is the difference between the wheelbase settings? There are two boxes with '1' for 1mm shim, then a 0. Should these not have 2, 1, 0, i.e. for having both shims at the front, 1mm either side and both at the back of the wishbone? Same question applies for the front. Thanks Skiddins |
Author: | Skiddins [ Wed Oct 02, 2013 15:17:21 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Will there also be an editable setup sheet released as well as the blank one? |
Author: | coastal [ Thu Oct 03, 2013 20:51:12 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Author: | Skiddins [ Thu Oct 03, 2013 20:57:58 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Author: | DaleBurr [ Fri Oct 04, 2013 11:25:36 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
I don't think it means anything, since 1=1. If you were using 2mm spacing at that end you would check both boxes to show a total of 2mm spacing. With 1mm spacing just check one box. |
Author: | mario [ Fri Oct 04, 2013 11:34:33 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Martin will give you an answer but he is on the way now to IIC race. |
Author: | Bonny [ Tue Oct 08, 2013 00:57:24 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Damian Surely its simply to note how many 1mm shims are at the front part of the wishbone? If you have two shims you simply tick both boxes? Mark |
Author: | Skiddins [ Tue Oct 08, 2013 01:47:15 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
Author: | beale [ Tue Oct 08, 2013 06:29:09 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
A tick in the front and back would mean central position I think, 2 ticks would mean wishbone all the way forward at the front or back at the rear and a tick in all boxes would mean longest wheelbase. |
Author: | Hagberg [ Tue Oct 15, 2013 22:40:07 ] |
Post subject: | Re: T4'14 Setup Sheet Question |
I am pretty sure that the boxes ticked equals how many shims that are placed in front of the arm. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |