XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Roll bar settings https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13660 |
Page 1 of 1 |
Author: | EPicLURcher [ Sun Sep 01, 2013 23:53:19 ] |
Post subject: | Roll bar settings |
I cant seem to Adjust the rear roll bars properly. When i lift one side up with shocks detached the other doesnt lift. It does at the front though. Ive played around with the grub screws but cant get it, any tips? |
Author: | beale [ Mon Sep 02, 2013 08:21:13 ] |
Post subject: | Re: Roll bar settings |
Take the roll bar out and lay it on a flat surface, Is it flat? If not twist it slightly till it sits flat, If its flat make sure your wishbones lift easily and fall under their own weight, Refit the bar at the back, the grub screws are to take out slop so don't "tighten" just nip the bar then back off till the bar swings freely then reattach the front links |
Author: | Skiddins [ Mon Sep 02, 2013 10:32:13 ] |
Post subject: | Re: Roll bar settings |
As above, plus make sure the drop links that attach the bars to the wishbone move freely and that the wishbones themselves are very free moving. Skiddins |
Author: | EPicLURcher [ Mon Sep 02, 2013 11:45:54 ] |
Post subject: | Re: Roll bar settings |
Thanks. The roll bar was twisted, back in shape now though. When i raise one side how much should the other lift? Same distance or just a few mm? |
Author: | Skiddins [ Mon Sep 02, 2013 13:14:14 ] |
Post subject: | Re: Roll bar settings |
Author: | Hagberg [ Wed Sep 11, 2013 12:26:59 ] |
Post subject: | Re: Roll bar settings |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |