XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
diffing out https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13623 |
Page 1 of 1 |
Author: | Nathan Wilson [ Sat Aug 03, 2013 10:10:09 ] |
Post subject: | diffing out |
I have heard people refer to a problem called diffing out and I think I am getting it. When going into a tight corner then getting on the power it seems like the rear is rolling to the point where the inside wheel lifts and spins causing the rear to be loose. How would I prevent this? I am quite stiff in the rear 2.7 with hole 3 from the inside and a high roll centre. Thanks |
Author: | Andrew Webber [ Sat Aug 03, 2013 10:43:42 ] |
Post subject: | Re: diffing out |
Are your downstops allowing the car to roll? The downstops could be too low and when the chassis rolls the inside wheel is lifting. |
Author: | Nathan Wilson [ Sat Aug 03, 2013 11:02:40 ] |
Post subject: | Re: diffing out |
4.2 at the rear |
Author: | Skiddins [ Sat Aug 03, 2013 11:32:04 ] |
Post subject: | Re: diffing out |
Thicker rear diff oil |
Author: | Andrew Webber [ Sun Aug 04, 2013 12:51:26 ] |
Post subject: | Re: diffing out |
Author: | Nathan Wilson [ Sun Aug 04, 2013 15:50:35 ] |
Post subject: | Re: diffing out |
Author: | Andrew Webber [ Sun Aug 04, 2013 21:59:41 ] |
Post subject: | Re: diffing out |
That all looks normal. Thicken up the oil like Skiddins recommended. |
Author: | Nathan Wilson [ Sun Aug 04, 2013 23:27:03 ] |
Post subject: | Re: diffing out |
Thanks 2k 3k or even more |
Author: | Skiddins [ Sun Aug 04, 2013 23:48:32 ] |
Post subject: | Re: diffing out |
Author: | Nathan Wilson [ Mon Aug 05, 2013 10:46:30 ] |
Post subject: | Re: diffing out |
Its quite low |
Author: | Skiddins [ Mon Aug 05, 2013 13:22:00 ] |
Post subject: | Re: diffing out |
Try 2k then and see how that goes. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |