XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Screws for clamping hubs? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13498 |
Page 1 of 1 |
Author: | Roachtek [ Mon Apr 29, 2013 17:59:17 ] |
Post subject: | Screws for clamping hubs? |
I purchased two sets of 305350-K clamping hubs and neither had screws in them. How am I supposed to use them if they won't clamp? Both packages were sealed at both ends and didn't appear to be tampered with. The screws aren't shown in the item description either. What part number do I need to order to get the screws for them if not supplied? |
Author: | Skiddins [ Mon Apr 29, 2013 23:46:28 ] |
Post subject: | Re: Screws for clamping hubs? |
I believe the small hex screws are M2 thread You could always remove the screws from the hexes you've taken off. |
Author: | brano [ Tue Apr 30, 2013 06:17:00 ] |
Post subject: | Re: Screws for clamping hubs? |
Author: | Roachtek [ Tue Apr 30, 2013 14:48:14 ] |
Post subject: | Re: Screws for clamping hubs? |
I went to my LHS and found some screws. M2 x 4 were a perfect fit. I'm just surprised they didn't come with screws. My old hexes were the plastic snap on variety as my car is a T3R so I didn't have any screws to start with. Thanks for the replies! |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |