XRAY - Model racing cars

Looking at the new setup sheets for the T4'14, what is the difference between the wheelbase settings?

There are two boxes with '1' for 1mm shim, then a 0.
Should these not have 2, 1, 0, i.e. for having both shims at the front, 1mm either side and both at the back of the wishbone?

Same question applies for the front.

Thanks
Skiddins

Will there also be an editable setup sheet released as well as the blank one?

I don't think it means anything, since 1=1. If you were using 2mm spacing at that end you would check both boxes to show a total of 2mm spacing. With 1mm spacing just check one box.

Martin will give you an answer but he is on the way now to IIC race.

Damian

Surely its simply to note how many 1mm shims are at the front part of the wishbone? If you have two shims you simply tick both boxes?


Mark

A tick in the front and back would mean central position I think, 2 ticks would mean wishbone all the way forward at the front or back at the rear and a tick in all boxes would mean longest wheelbase.

I am pretty sure that the boxes ticked equals how many shims that are placed in front of the arm.