XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Bodyshell Clearance!! https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13418 |
Page 1 of 1 |
Author: | Matt W [ Sat Mar 09, 2013 13:36:26 ] |
Post subject: | Bodyshell Clearance!! |
Hi, I was wondering when racing on carpet how much clearance you give the bodshell to the ground? When using a ride height gauge I usually aim for around 10mm all round but was wondering if this was too much? |
Author: | Skiddins [ Sat Mar 09, 2013 14:58:09 ] |
Post subject: | Re: Bodyshell Clearance!! |
High enough so it doesn't rub on the ground. It will vary depending on how stiff your suspension is. Skiddins |
Author: | Matt W [ Sat Mar 09, 2013 16:01:24 ] |
Post subject: | Re: Bodyshell Clearance!! |
Everyone with an xray will all run fairly similar in stiffness and roll, (roughly). Out of interest how much clearance in millimeters do you give your bodyshells all round? |
Author: | Skiddins [ Sat Mar 09, 2013 22:37:35 ] |
Post subject: | Re: Bodyshell Clearance!! |
Looks like the sides of mine are around 9mm, but I could probably go down 1 or 2mm. Skiddins |
Author: | Sid [ Sun Mar 10, 2013 05:48:15 ] |
Post subject: | Re: Bodyshell Clearance!! |
Never measured but I raised the body 1 step from what the instuction book say and cut 2-3mm above the cutting line on a lctr. That is about the lowest possible with standard setup. |
Author: | Hagberg [ Mon Mar 11, 2013 18:13:37 ] |
Post subject: | Re: Bodyshell Clearance!! |
When watching the car from the side I eyeball it so that it should be in line with the chassis. The front, cut the lip away until its not rubbing. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |