| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Motor guard-spur saver? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13412 |
Page 1 of 1 |
| Author: | EPicLURcher [ Wed Mar 06, 2013 18:57:20 ] |
| Post subject: | Motor guard-spur saver? |
Hi, I have a problem with my t4, and that is that spur strips regularly. I have narrowed the problem down to that as we have a tight track with wood sides when we hit the i think that the motor is actually hitting these boards and moving towards the spir stripping them. Do you thing that a motor guard would stop this? |
|
| Author: | Skiddins [ Wed Mar 06, 2013 21:11:28 ] |
| Post subject: | Re: Motor guard-spur saver? |
It might work. Are you sure this is where the problem is and not the motor moving forwards or backwards. Make sure you tightened up the screws and nut for the motor mount in the right order. Skiddins |
|
| Author: | EPicLURcher [ Wed Mar 06, 2013 22:31:45 ] |
| Post subject: | Re: Motor guard-spur saver? |
Yeah i stripped a few spurs and have had to check this before. My motor strips if you tighten the screw too much, its a hard thing to do. |
|
| Author: | riketsu [ Fri Mar 08, 2013 15:41:10 ] |
| Post subject: | Re: Motor guard-spur saver? |
Use M3 socket head screws for the motor AND motor bulkhead (screws below the bearing that hold the motor mount). Tighten screws in the same order the manual says. These socket head screws permit you to tighten them better than the button head screws. Motor guard might help, but tightening the motor correctly may "fix" it also. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|