XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4 64 pitch pinion defective ? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13278 |
Page 1 of 1 |
Author: | yunowill [ Tue Jan 15, 2013 06:18:59 ] |
Post subject: | T4 64 pitch pinion defective ? |
Hey guys I just finished setting my car up . I grabbed a 92T 64P spur and a 44T 64P pinion for it to achieve my FDR . However I think my spur gear might of came out as a bad mold from the factory , As when I meshed the gear it was perfectly smooth and properly meshed all the way around like butter ...but there seam to be a high spot on the spur gear as when it hits a certan spot about 1/8 inch part of it , it gets real tight then goes back to being properly meshed with the rest of the gear . I did try meshing it on the "high spot " to smooth it out but when I rolled it over to the smoother part of the gear it was way too loose ... I didnt want to even run the car as I know those teeth would last for 3 feet and be gone . The pinion is fine as I swapped it into my other touring car to see if the pinion was causing the issue and its not . Any suggestions on this ? Or should I just pitch it in the garbage and grab another gear . Thanks Will, |
Author: | Hagberg [ Tue Jan 15, 2013 10:00:02 ] |
Post subject: | Re: T4 64 pitch pinion defective ? |
Go to your local LHS to try and get it replaced. If its defective from the factory I am sure XRAY will replace it. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |