XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Spring tension adjustment. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13215 |
Page 1 of 1 |
Author: | DPL [ Sun Dec 30, 2012 16:56:44 ] |
Post subject: | Spring tension adjustment. |
I just bought the T4 and got it completely built. Starting now to set it up. My question is this: What is the correct way to adjust the aluminum cap on the shock body? Do I adjust it until it places tension on the spring or should I adjust it some what tighter then that. I am using the springs that came with the kit. Thanking you in advance concerning this question. DPL |
Author: | spotlessdragon [ Sun Dec 30, 2012 18:54:46 ] |
Post subject: | Re: Spring tension adjustment. |
the collars adjust ride hight only not spring tension. you need different springs for that but most people are using 2.7 front 2.5 rear |
Author: | spotlessdragon [ Sun Dec 30, 2012 18:56:12 ] |
Post subject: | Re: Spring tension adjustment. |
kit rears are good when grip is low |
Author: | Hagberg [ Wed Jan 02, 2013 15:19:23 ] |
Post subject: | Re: Spring tension adjustment. |
The preload directly affects chassis ride height. A good starting point for ride height with 62mm big rubber tires is 5mm front and 5.3mm rear. The spring should have some tension on it with this setting but not a lot. The rear spring can be free and even have play if you use a lot of droop and when unloaded. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |