XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T4 Setup: Rear anti-rar - both sides do not move together https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13176 |
Page 1 of 1 |
Author: | wsl [ Mon Dec 17, 2012 18:59:10 ] |
Post subject: | T4 Setup: Rear anti-rar - both sides do not move together |
Hi all, I am setting the T4 and encounter a problem on page 21 of the instruction manual: setting rear anti-roll bar. When I moved the left arm, right moved much later; when i moved the right arm, left did not move. I checked the bar wire, seems ok. I moved the bar wire out, flip-over and installed again but with same problem. Checked the downstops, both are the same. Please kindly advice what else could i try to resolve this? Many thanks BTW, the front anti-roll bar is ok, both sides moved "almost" together. |
Author: | wsl [ Mon Dec 17, 2012 19:14:02 ] |
Post subject: | Re: T4 Setup: Rear anti-rar - both sides do not move togethe |
just found some discussion on this problem on rc tech forum...will try..hope it will solve it http://www.rctech.net/forum/electric-ro ... st11514672 |
Author: | Green Wing [ Tue Dec 18, 2012 19:05:51 ] |
Post subject: | Re: T4 Setup: Rear anti-rar - both sides do not move togethe |
The problem could be that: - the wires don't have the same position in the ballends. Both setscrews need to sit in the very same position. - the length of the wires +/- the ballends are different to each other. - the the ARB connectors are not the same length for 100%. - the play in both composite seats of the wire is not adjusted for the same amount. - one of the arm holder screws is bent or has a bad head. Later, this can occur when the chassis is tweaked. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |