XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
DJC front axles https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=13125 |
Page 1 of 1 |
Author: | Kensei [ Mon Nov 26, 2012 16:13:06 ] |
Post subject: | DJC front axles |
Which ones best to use on the T4? 50mm or 52mm. Do both fit without problems or additional changes I have to do? Would like to know before I spend my hard earned money ![]() I ask because info in manual and on seperate leaflet are not the same! Do I have to use shrink tube? In the manual and in the seperate leaflet it is not mentioned, so I opt for not doing so........ Thnx |
Author: | Skiddins [ Mon Nov 26, 2012 20:03:43 ] |
Post subject: | Re: DJC front axles |
They will both fit, but when using the 50mm versions you are more likely to break the spool outdrives, but many say these give more traction at the front end. I always build the driveshafts as the instructions say, but then put some heatshrink on them to help keep them together if a pin comes loose etc. Transparent heatshrink is better for this |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |