Building Problem Steering T4

Racing Hacki · **Posted:** Sat Oct 20, 2012 07:38:36

Hi!

I need help because i have a problem with the turnbuckle screw from the servosaver to the steering. This screw is sliding on the top deck if i use the recommended hole from the manual on the servo saver. I am using a Savöx 1251MG Servo.

How can i solve the problem?

Thx for help
Martin

Andrew Webber · **Posted:** Sat Oct 20, 2012 10:01:20

Hi Martin,

Have you tried loosening the screws off that hold the servo in place, pushing the servo all the way down, and retightening the screws again?
Sometimes its possible, depending on the servo, to get close to 1mm of movement up and down of the servo and that might be enough to help with clearance.

Cheers
Andrew

Racing Hacki · **Posted:** Sat Oct 20, 2012 14:32:20

Skiddins · **Posted:** Sat Oct 20, 2012 16:10:04

Check that you followed which way up the plastic arms are in the following picture, you have definitely put them on the wrong way up;

Racing Hacki · **Posted:** Sat Oct 20, 2012 16:36:21

As you can see on the picture i think they look like right! I will have a look to be sure!

Edit: it's like in the manual!

Greets

Skiddins · **Posted:** Sat Oct 20, 2012 20:10:25

It has happened a lot of times.

Racing Hacki · **Posted:** Sat Oct 20, 2012 20:43:03

It's like in the manual!

Skiddins · **Posted:** Sat Oct 20, 2012 21:55:22

Can you take a picture of where the problem is happening?

Martin Hudy · **Posted:** Tue Oct 23, 2012 07:49:20

Maybe servo is mounted too high on the servo holder. Try to untight the screws which connects servo with the holder and push it more down. The servo holes are big and they allow you to move with the servo. If it is still not enough, than replace the shim that connect linkage with the steering plate. Instead of that big shim, use 4mm shim (2 shims of 3x6x2)

XRAY - Model racing cars

Building Problem Steering T4

Who is online