XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Free lower arms https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12783 |
Page 1 of 1 |
Author: | valentin lehmann [ Sun Aug 19, 2012 11:14:16 ] |
Post subject: | Free lower arms |
Hi, Could anyone explain me his building technic to get free lower arms with the minimum play between them and roll center plastic blocks? Thanks |
Author: | Skiddins [ Sun Aug 19, 2012 18:47:09 ] |
Post subject: | Re: Free lower arms |
You need to get a 3mm reamer to open the holes for the pivot pins very slightly. If the problem is the spacers are too tight then you need to try pushing the roll centre mounts apart while tightening them up. Skiddins |
Author: | Chicane [ Mon Aug 20, 2012 19:29:26 ] |
Post subject: | Re: Free lower arms |
I pinch the blocks together while tightening the screws, then hit the arms from both sides with the big end of a wrench, to free the arm, if nothing is bent or warped with the correct shims, this will results in a free and tight arm. If you run the car once and the arms develop a lot of play chances are the RC holders need to be replaced. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |