| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| When shocks are news https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12725 |
Page 1 of 1 |
| Author: | Ruben_qlc [ Tue Jul 17, 2012 11:03:09 ] |
| Post subject: | When shocks are news |
Hello everybody. WHen you get the car with the shocks. You have to do a hole on the cap for better rebound adjustment, correct? How many width would have this hole? Then on piston, you have to dot hole of 1.1mm, correct? What do you think about it? Thank you. |
|
| Author: | Skiddins [ Tue Jul 17, 2012 14:34:22 ] |
| Post subject: | Re: When shocks are news |
The hole in the plastic part of the cap will give you no rebound. The hole is normally 1mm. Most drivers seem to use 3 hole 1.1mm pistons |
|
| Author: | Ruben_qlc [ Tue Jul 17, 2012 14:50:46 ] |
| Post subject: | Re: When shocks are news |
The hole in the cap give you no rebound? totally 0 rebound? If you don't do the hole, you can do the same but with a lot of spent time? |
|
| Author: | Skiddins [ Tue Jul 17, 2012 20:56:05 ] |
| Post subject: | Re: When shocks are news |
When assembling the shock, if you put the cap on etc. with the shaft all the way in you will get close to zero rebound or possibly a little. Skiddins |
|
| Author: | Ruben_qlc [ Tue Jul 17, 2012 22:20:36 ] |
| Post subject: | Re: When shocks are news |
Thank you very much Skiddins. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|